iStick Pico 75W Starter Kit with MELO III tank

iStick Pico 75W Starter Kit with MELO III tank
Back by popular demand - the iStick Pico 75w Kit!
NZ$ 79.95 including GST
NZ$ 69.52 excluding GST
Purchase Qty:

The iStick Pico is consistently the most highly reviewed sub-ohm mod kit for beginners. Powered by single interchangeable 18650 cell, it provides you with 75W maximum output and switchable VW/Bypass/TC-Ni/TC-Ti/TC-SS/TCR modes. With top e-liquid filling design, hidden airflow control and detachable structure, the new MELO III Mini is the best match for the iStick Pico.  


Standard configuration:

  • 1×iStick Pico (without battery)
  • 1×MELO III Atomizer  
  • 1×EC 0.3ohm Head      
  • 1×EC 0.5ohm Head   
  • 4×Seal Ring    
  • 1×USB Cable   
  • 2×User Manual  


Size: 45mm*23mm*70.5mm
Thread type: 510 thread
Cell type: High-rate 18650 cell (min 25A, Sony VTC4 recommended)
Cell type:(Continuous discharge current should be above 25A)
Output mode: VW/Bypass/TC(Ni,Ti,SS,TCR-M1,M2,M3) mode
Output wattage: 1-75W
Resistance range: 0.05-1.5ohm (TC modes)
Resistance range:0.1-3.5ohm (VW/Bypass mode)
Temperature range: 100-315℃/200-600℉ (TC modes)

Diameter: 22mm
Length: 55mm
Capacity: 4ml
Thread type: 510 thread
Material: 304 stainless steel

TC-SS and TCR Modes Available

Despite the compact size, the iStick Pico allows an intelligent but yet satisfying draw with 75W maximum output and switchable VW/Bypass/TC(Ni,Ti,SS,TCR) modes. 

Interchangeable 18650 Cell

Users can carry spare cells when on the go and change the cell easily by removing the battery cap only. 

Detachable Structure

All the parts of MELO III Mini can be detached, bringing more convenience in reassembling and cleaning.  

Unique Bottom Design

The ventilation holes at the bottom are for better heat dissipation and the adjustment buttons are located at the bottom as well. 

Micro USB Port

Charging: The 18650 cell can be charged in the iStick Pico through the side USB port via 1A wall adapter or computer or charged with an external battery charger. The recommended way is to charge the cell externally as it will take less time to give the cell a full charge. 

Firmware upgrading

The firmware can be upgraded by connecting the device with a computer through the USB port via a micro USB cable. 

Tip for new users: We strongly suggest 6mg e-Liquid or lower with this atomizer. Sub-ohm atomizers produce higher throat hit than low and standard resistance atomizers. Using this atomizer with a nicotine level above 6mg will usually taste burnt or harsh. Use high VG e-liquid if you are a cloudchaser.

NOTE: Use special caution when working with Li-ion cells, they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure the user has enough knowledge of Li-Ion rechargeable batteries in charging, discharging and assembly before use. Always charge in/on a fire-proof surface. Never leave charging batteries unattended. We are not responsible for damage if there is any modification of the batteries/chargers in any form or shape (including pack making). We are not responsible for any damage caused by misuse or mishandling of Li-Ion batteries and chargers.


This tank uses sub-ohm resistance coils. This tank should only be used by experienced users. Extra safety precautions should be practiced when using a sub ohm tank. This tank will only work on a mechanical mod or a regulated mod capable of firing sub ohm atomizers and coils. For example, if you have a 0.2ohm coil, your mod must be able to fire atomizers of 0.2ohm or lower. You must be also ensure that your batteries can handle sub ohm atomizers and coils. If you're using a regulated mod, make sure it can handle the amps. Improper use can lead to injury or damage. For mechanical mod users, please use 30 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.

This device should only be used with rechargeable Lithium Ion IMR batteries with an amp limit of 20A or higher. Using other batteries can be potentially hazardous.

  • Sony VTC4 18650 2100mAh
    NZ$ 9.95
    NZ$ 8.65 excl GST
    View / Add
  • Replacement glass for tanks
    NZ$ 5.00
    NZ$ 4.35 excl GST
    View / Add
  • iStick Pico Silicone sleeve
    NZ$ 4.00
    NZ$ 3.48 excl GST
    View / Add
  • Eleaf EC Replacement Coils for MELO and iJust tanks
    NZ$ 5.00
    NZ$ 4.35 excl GST
    View / Add
  • GeekVape Aegis 100W 26650 TC Kit with Shield Tank
    NZ$ 129.95
    NZ$ 109.95
    NZ$ 95.61 excl GST
    View / Add
  • Eleaf iJust S Starter Kit
    NZ$ 59.95
    NZ$ 52.13 excl GST
    View / Add
  • iJust S 3000mAh battery only
    NZ$ 34.95
    NZ$ 30.39 excl GST
    View / Add
  • Uwell Nunchaku 80W Vape Pen Kit
    NZ$ 139.96
    NZ$ 121.70 excl GST
    View / Add
  • iStick Pico S 100W with 21700 battery Kit
    NZ$ 169.95
    NZ$ 149.95
    NZ$ 130.39 excl GST
    View / Add
  • Innokin Endura T20S Starter Kit
    NZ$ 49.94
    NZ$ 43.43 excl GST
    View / Add

Product Search

Price From
Sort By
Other Filters

Connect With Us

To visit our website you must to be 18 years or older.

Please confirm.